Climatic sensors (combined temperature and humidity sensors)
These components cover sensory supervision. Sensor components of the ELM system are generic. No special sensors or interface controller are required and there is no dependence of a specific manufacturer. Any simple transducer that can produce 0 – 7.5 V DC can be used. (The input is protected against overload from -25..+30V.) The conversion of the measured voltage into the range of the physical measurand is carried out by software.
EMKA Electronic provides several specific sensors for the most usual tasks. - Click on a link for a detailed description of these sensors:
|
|
|
|
|
Climatic sensors (combined temperature and humidity sensors) |
|
|
|
|
|
|
|
|
Switched socket outlets with/without observation of mains power |
|
|
An upper as well as a lower set point can be defined individually for every sensor component. A relay contact can be assigned to each set point which then becomes powered when the sensor value exceeds the set point. Furthermore, each set point can be assigned to one of two alarm lines.
Sensor components are available on the following modules:
| Designation of module (Click on a designation for a detailed description.) |
Number of
sensor components on module (See the detailed description of the module for further details and for connectable devices.) |
Other components
available on module (may be optionally equipped)
|
Ordering designation of module |
 Sensor module |
4 sensor inputs |
4 Switching components |
3000-U13 |
|
LMSR module |
1 sensor inputs |
1 Switching component 1 User Interface Component 1 Components for door locking control |
3000-U15 |
See also (information becomes more general downwards):
|
|
Components - Overview |
|
|
ELM system - Overview |